How do you measure the efficiency of heat pump?
Are you looking for an alternative method of heating and cooling your home? Many people turn to heat pumps. But we can measure the efficiency of the heat pump? Well, there are four types of measurements that are used to describe the specific efficiency. Each of these individual measurements can be used anytime.
This article will provide some light on the efficiency of the method for determining the heat pump. A methodcompare, consume the amount of energy supplied by the pump to the actual amount.
One thing to keep in mind, the comparison of measurement for heat pump efficiency, the higher the number, the greater the actual efficiency of the pump.
The most common measure for the heat pump performance is the coefficient of performance COP o. This refers to the ratio of the heat pump to heat the BTUThe BTU output of electricity. A water or geothermal heat pump has a score of 04:57. An air-source heat pump usually has a rating of three fifty-COP. When the outdoor temperature decreases, heat pumps, air-COP decreases by. Therefore, when comparing these estimates, the air temperature to make sure based on the outside thereof.
Another method to determine the efficiency of heat pumpthe energy efficiency ratio EER o. This increases the efficiency during the cooling circuit of the device. This assessment is also used for air conditioners. When the EER rating is greater than ten, then that is a good car.
Note that this measure the efficiency of heat pumps are basically factory or laboratory tests. The heat pump in question could actually another measurement of the actual use. This measure may be differentdepending on how long or how much additional heat is required. Therefore, measuring the best or is more realistic seasonal calculations. The HSPF ratings are seasonal and visionaries.
The heating seasonal performance factor or HSPF is another of the efficiency measures of the heat pump. If the value is between 5-7, then this is a good credit rating to have. Seer or Seasonal Energy Efficiency Ratio is a measure ofTotal cooling capacity in BTU. A good rating is SEER 8:00 to 10:00.